Intended for rounded corner application points on thermoplastic parts such as bumpers and clips
A curved application staple, it can help with a rounded corner
This is an alternative to the M-Clip which would leave an exposed staple
Also effective in curved areas around screw and plastic rivet holes
This small design element will cut cycle time and save technicians extra steps
The leads are notched like someone took an axe to a tree, allowing them to be snapped off with a hand, instead of having to go back with snips
The time savings does not stop there: if sunken deep enough the leads will break below the surface of the plastic eliminating the need to go back over with a grinder later
Over time these simple improvements make the difference in profitability and not going over the allocated time