11,000lb capacity asymmetric / symmetric two post overhead vehicle lift
Rigid single piece column construction provides strength and durability
Bi-Symmetric arm design offers the best of both worlds allowing both asymmetric and symmetric lifting by using a three stage short arm that can be set for either asymmetric or symmetric lifting
Reduced overall width while maintaining drive thru with front mounted power unit
Direct pull style cylinder
Pull style cylinders become stronger as the vehicle raises vs a push style cylinder that is at its weakest point when the vehicle is fully raised
Rubber door guards limit damage to car doors when entering and exiting a vehicle
Low profile arms with a pad height of 4� allows lifting of the even the lowest sport cars
Spin up lifting pads allow for 2 1/8� of adjustment
This often allows the technician to contact the lifting point prior to lifting for positive lifting point engagement
Truck adapters allow raising of the lifting pad to lift around running boards or to access recessed lifting points
Also can be used on some vehicles to realize �extra� lift height
Four each 2� and 4� adapters included
Padded overhead shut off protects vehicle by cutting power to the motor when contacted by the lifted vehicle
Single point lock release provides single side controls reducing down cycle operation time when compared to dual point lock release
Internal hose routing eliminates damage that might occur if hoses were externally routed and provides for a clean professional look
Automatic arm restraints integrated into the carriage design to eliminate potential contact when exiting vehicle
Durable powder coat finish
Optional: Spin up style cradle adapters for positive frame engagement